Aller au contenu principal

Aruba Standard

Prerequisites

Centreon Plugin

Install this plugin on each needed poller:

yum install centreon-plugin-Network-Switchs-Aruba-Standard-Snmp

Configure SNMP

Follow constructor procedure to enable and configure SNMP on the equipment.

Read this guide to troubleshoot SNMP problems.

Centreon Configuration

Create hosts using the appropriate template

Both controllers and access points can be monitored using specific host templates.

Be sure to have with you the following information:

  • Read-only SNMP community
  • IP Address of the equipment

Controller

Go to Configuration > Hosts and click Add. Then, fill the form as shown by the following table:

FieldValue
NameName of the controller
AliasDescription
IP Address / DNSIP address of the controller
SNMP Community & VersionCommunity and version of the SNMP agent
Monitored fromPoller used to monitor
TemplatesNet-Aruba-Standard-Controller-SNMP-custom

Check the Create Services linked to the Template too box and click on the Save button.

The following services will be created:

  • Cpu
  • Memory
  • Storage
  • Hardware
  • License
  • Controller-Status

The following rules are linked to this host template:

  • Net-Aruba-Standard-SNMP-Packet-Errors-Name
  • Net-Aruba-Standard-SNMP-Traffic-Name

Access Point

Go to Configuration > Hosts and click Add. Then, fill the form as shown by the following table:

FieldValue
NameName of the access point
AliasDescription
IP Address / DNSIP address of the controller
SNMP Community & VersionCommunity and version of the SNMP agent
Monitored fromPoller used to monitor
TemplatesNet-Aruba-Standard-Ap-SNMP-custom

The following host macros should be set as shown:

MacroValue
APNAMEName of the access point

Check the Create Services linked to the Template too box and click on the Save button.

The following services will be created:

  • Ap-Ssid-Statistics
  • Ap-Status