Skip to main content

HP Moonshot SNMP

Pack Assets

Monitored Objects

The Centreon Pack HP Moonshot SNMP brings a host template:

  • Net-Hp-Moonshot-SNMP-custom

It brings the following service templates:

Service AliasService TemplateDescriptionDefault
CpuNet-Hp-Moonshot-Cpu-SNMPCheck CPUX
InterfacesNet-Hp-Moonshot-Interfaces-SNMPCheck interfaces
MemoryNet-Hp-Moonshot-Memory-SNMPCheck memoryX

Discovery rules

Rule nameDescription
Net-Hp-Moonshot-SNMP-Interface-NameDiscover network interfaces and monitor usage

More information about discovering services automatically is available on the dedicated page and in the following chapter.

Collected metrics & status

Metric nameUnit
cpu.utilization.5s.percentage%
cpu.utilization.1m.percentage%
cpu.utilization.15m.percentage%

Prerequisites

SNMP Configuration

To use this Pack, the SNMP service must be properly configured on your device.

Network flow

The target equipment must be reachable from the Centreon Poller on the UDP/161 SNMP port.

Setup

  1. Install the Centreon package on every Centreon poller expected to monitor HP Moonshot resources:
yum install centreon-plugin-Network-Hp-Moonshot-Snmp
  1. On the Centreon web interface, install the HP Moonshot SNMP Centreon Pack on the Configuration > Monitoring Connector Manager page.

Configuration

Host

  • Log into Centreon and add a new host through Configuration > Hosts.
  • Fill the Name, Alias and IP Address / DNS fields according to your HP Moonshot equipment settings.
  • Apply the Net-Hp-Moonshot-SNMP-custom template to the host.
  • Once the template is applied, fill in the corresponding macros. Some macros are mandatory.

When using SNMP v3, use the SNMPEXTRAOPTIONS Macro to add specific authentication parameters More information in the Troubleshooting SNMP section.

MandatoryNameDescription
SNMPEXTRAOPTIONS(Default: 'Configure your own SNMPv3 credentials combo')

How to check in the CLI that the configuration is OK and what are the main options for?

Once the plugin is installed, log into your Centreon poller's CLI using the centreon-engine user account (su - centreon-engine) and test the plugin by running the following command:

/usr/lib/centreon/plugins/centreon_hp_moonshot_snmp.pl \
--plugin=network::hp::moonshot::snmp::plugin \
--mode=cpu \
--hostname=10.30.2.114 \
--snmp-version='2c' \
--snmp-community='hp_ro' \
--warning-cpu-utilization-15m='90' \
--critical-cpu-utilization-15m='95' \
--verbose

The expected command output is shown below:

OK: cpu average usage: 27.13 % (5s), 22.34 % (1m), 17.98 % (15m) | 'cpu.utilization.5s.percentage'=27.13%;;;0;100 'cpu.utilization.1m.percentage'=22.34%;;;0;100 'cpu.utilization.15m.percentage'=17.98%;0:90;0:95;0;100

All available options for a given mode can be displayed by adding the --help parameter to the command:

/usr/lib/centreon/plugins/centreon_hp_moonshot_snmp.pl \
--plugin=network::hp::moonshot::snmp::plugin \
--mode=cpu \
--help

All available modes can be displayed by adding the --list-mode parameter to the command:

/usr/lib/centreon/plugins/centreon_hp_moonshot_snmp.pl \
--plugin=network::hp::moonshot::snmp::plugin \
--list-mode

Troubleshooting

Please find the troubleshooting documentation for Centreon Plugins typical issues.